analogmascon

差分

このページの2つのバージョン間の差分を表示します。

この比較画面へのリンク

--- analogmascon [2014/12/25 20:03]
– created yaasan
+++ analogmascon [2014/12/25 20:10] (現在)
– [How to connect] yaasan
@@ 行 4: / 行 4: @@
 DSmain has an interface of analog PWM. You can connect your analog PWM controller to DSmain.
+The structure shows as the following.
+{{http://buin2gou.sakura.ne.jp/sblo_files/powerele/image/MasconCnv_06-thumbnail2.png}}
+The schematic is the below. This schematic applies to DSmain.
+{{http://buin2gou.sakura.ne.jp/sblo_files/powerele/image/MasconCnv_02-thumbnail2.png}}
 ===== How to connect =====
-If you have [[http://www.tomytec.co.jp/diocolle/lineup/tetsudou_seigyo/index.html|JR101 analog controller]], you can setup like the following. You need 2 jumper wires to connect between DSmain and the analog controller.
+If you have [[http://www.tomytec.co.jp/diocolle/lineup/tetsudou_seigyo/index.html|JR101 analog controller]], you can setup like the following.
+{{http://buin2gou.sakura.ne.jp/sblo_files/powerele/image/MasconCnv2_02-thumbnail2.jpg}}
+You need 2 jumper wires to connect between DSmain and the analog controller.
 {{http://yaasan.mints.ne.jp/gateway/figures/DSMR2_PCB9_thm.jpg}}
+===== How to control =====
+You need to upload the supported sketch to the DSmain. The sketches are DSmainRx.
+{{http://buin2gou.sakura.ne.jp/sblo_files/powerele/image/MasconCnv2_07-thumbnail2.jpg}}

analogmascon.1419505417.txt.gz · 最終更新: 2014/12/25 20:03 by yaasan