play_station_joystick
文書の過去の版を表示しています。
Replace S88 I/F to Playstation joystick
DSmainR4 supports to connect Playstation joystick instead of S88 decoders. This page describes how to make the conversion board.
About this
DSmainR4 is using PSXLibrary. Please download and copy it to Arduino IDE's libraries folder.
Wire assignment
Playstaion | S88 | S88-N(Ether) | Arduino | Notes |
---|---|---|---|---|
1.DATA | 3.CLOCK | 4.CLOCK | D3 | |
2.COMMAND | 4.LOAD | 6.LOAD | D4 | |
3.N/C (9 Volts unused) | N/C | N/C | N/C | |
4.GND | 2.GND | 3.GND, 5.GND | GND | |
5.VCC | 6.+5V | 1.+5V | 5V | |
6.ATT | 1.DATA | 2.DATA | A0 | |
7.CLOCK | 5.RESET | 7.RESET | D5 | |
8.N/C | N/C | N/C | N/C | |
9.ACK | N/C | N/C | N/C |
Soldering instruction
- Get PS-USB conversion device like ELECOM's JC-PS101U.
- Get a cheap Ethernet cable.
- Unsolder internal PCB and PS female connector.
- Cut Ethernet cable
- Solder the wire of Ethernet cable and PS female connector.
- Finish!
play_station_joystick.1434057682.txt.gz · 最終更新: 2015/06/12 06:21 by yaasan