desktop_station_s_serial_communication_specification
差分
このページの2つのバージョン間の差分を表示します。
両方とも前のリビジョン前のリビジョン次のリビジョン | 前のリビジョン次のリビジョン両方とも次のリビジョン | ||
desktop_station_s_serial_communication_specification [2017/06/05 06:24] – [Communication procedure] yaasan | desktop_station_s_serial_communication_specification [2017/07/08 20:47] – yaasan | ||
---|---|---|---|
行 22: | 行 22: | ||
コマンドの構造は、「コマンド名(引数1, | コマンドの構造は、「コマンド名(引数1, | ||
+ | |||
+ | コマンドを送る場合、200 Okの応答からウェイトを最低100ms以上置いてください。内部で処理を行ってDCCパルス生成器を確実に動作させるために必要です。 | ||
===== Command list ===== | ===== Command list ===== | ||
行 52: | 行 54: | ||
|CV Value | 0-255 | Locomotive' | |CV Value | 0-255 | Locomotive' | ||
+ | 以下のテーブルは、ロコとポイントのアドレス(1-65535)の意味をあらわしてます。\\ | ||
The following table describes Locomotive' | The following table describes Locomotive' | ||
行 83: | 行 86: | ||
===== Example of communication log ===== | ===== Example of communication log ===== | ||
+ | |||
+ | 以下は、通信ログの例です。setPing()を投げて生存確認をしてから、setPower(1)で線路電源のON、そのあとはコマンドを打てばその通りにDCC信号が出力されます。 | ||
< | < | ||
行 121: | 行 126: | ||
[RECV]200 Ok | [RECV]200 Ok | ||
</ | </ | ||
+ | |||
+ | ===== 外部操作の注意点 ===== | ||
+ | |||
+ | * 本体でDCC電源のON/ | ||
+ | * 本仕様書は随時更新されます。また、予告なしに仕様が変更される場合があります。 | ||
+ | * 本仕様書に記載の事項で、自動運転装置インテグレーションすることは自由ですが、当社は一切の動作保証、環境に起因するサポートをいたしません。サポートを要求される場合には、サポート契約を申し込みください。サポート契約外のサポートについては一切お断りいたします。 | ||
+ | |||
+ | |||
+ | |||
+ |
desktop_station_s_serial_communication_specification.txt · 最終更新: 2023/12/26 21:00 by yaasan