play_station_joystick
目次
Replace S88 I/F to Playstation joystick
DSmainR4 supports to connect Playstation joystick instead of S88 decoders. This page describes how to make the conversion board.
About this
DSmainR4 is using PSXLibrary. Please download and copy it to Arduino IDE's libraries folder.
Supporting joystick
- Taito's Densha-de-go One handle master controller
Wire assignment
| Playstaion | S88 | S88-N(Ether) | Arduino | Notes |
|---|---|---|---|---|
| 1.DATA | 3.CLOCK | 4.CLOCK | D3 | |
| 2.COMMAND | 4.LOAD | 6.LOAD | D4 | |
| 3.N/C (9 Volts unused) | N/C | N/C | N/C | |
| 4.GND | 2.GND | 3.GND, 5.GND | GND | |
| 5.VCC | 6.+5V | 1.+5V | 5V | Supported 3 to 5V |
| 6.ATT | 1.DATA | 2.DATA | A0 | |
| 7.CLOCK | 5.RESET | 7.RESET | D5 | |
| 8.N/C | N/C | N/C | N/C | |
| 9.ACK | N/C | N/C | N/C |
If you want to use a standard Ethernet cable, please see this page for Ethernet cable pin specification.
Wiring diagram
S88 pin assignment
Soldering instruction
- Get PS-USB conversion device like ELECOM's JC-PS101U.
- Get a cheap Ethernet cable.
- Unsolder internal PCB and PS female connector.
- Cut Ethernet cable
- Solder the wire of Ethernet cable and PS female connector.
- Finish!
Example soldering and assembling
If you are using Cat.5e Ethernet cable, See T568B wiring specification. If Cat.5, See T568A wiring specification.
The following assembling example is using Cat.5e cable.
play_station_joystick.txt · 最終更新: 2015/06/27 09:47 by yaasan